Netatmo Wind Gauge Pole Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for Netatmo Wind Gauge for pole mount (diameter of pole is 4 cm). Designed with holes for plastic ties.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 154
- Wydruki
- 0
- Wyświetlenia
- 1210
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- GNU General Public License v2.0
Holder for Netatmo Wind Gauge for pole mount (diameter of pole is 4 cm). Designed with holes for plastic ties.
At bottom is a hole for securing gauge with screw - same size as for camera tripods. I dismounted screw form some cheap small camera tripod.
After print I discovered, that gauge is quite firm in holder, so maybe screw is not necessarilly needed :-)
I used SketchUp to design this piece. Source file included.
Still ok after 3 years - made from PLA.
Print instructions
Category: Outdoor & Garden Print Settings
Printer: Prusa i3 original
Resolution: 200
Infill: 40 honeycomb 3D