Logitech G RS50 Phone Holder

The RS50 phone holder can be mounted to the front of the direct drive motor by replacing the 2 M6 screws on the face. It is height adjustable and will fit devices from 70-100mm. The design does not block the screen on the motor and allows easy access to the options button. It can be printed all at once on one plate and requires minimal supports.

Hardware needed

• 2x M6x30 machine screws

• 3x M3x8 machine screws with washers
  or
  3x M3x6 machine screws without washers

• 3x M3 nuts

To assemble

• Insert the nuts into the hex slots. Some persuasion may be necessary.

• Insert screws through the slots on the lower plate and attach to the base plate

  • The nuts on the base plate should be on the back side while the nut on the upper plate should be on the front.

• slide the upper plate onto the lower plate

• Insert screw through the slot on the upper plate

Notes

If you are using washers, you may need M3x8 screws. You can use M3x8 or x6 screws without washers to attach the lower plate to the base plate, however, you will want to make sure the screw you use to attach the upper plate doesn't protrude too far past the nut as this will cause it to touch the mounted device.

Feel free to offer feedback for improvement.