Droplets on Autumn Leaves Bookmark set

Thank you for downloading my works. If you would like to sell my designs, past and future, a commercial license can be obtained from my MakerWorld or Patreon page.

Fall approaches, leaves turn beautiful hues of red, orange, and yellow, and then descend to earth. A little addition of water droplets on them to further beautify the change. Can print them without tassel option (Plate 1) or with tassel punchout(Plate 2). 

Pictures shown are printed in an 0.2mm Nozzle
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm 

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Red Transmission Distance: 4

PLA BambuLab Basic Yellow Transmission Distance: 6

PLA BambuLab Basic Jade White Transmission Distance: 5

This print uses 4 unique filaments 

Swap Instructions:

Start with Black

At layer (0.72mm) swap to Red

At layer (1.04mm) swap to Yellow

At layer (1.36mm) swap to Jade White for the rest. 

Can be resized to accommodate your printer or preference by adjusting the X and Y axis the same percentage while leaving the Z axis at 100%. The best way to achieve this: With Uniform Scale checked, adjust the Y axis to the desired size (this will ensure the X axis is the same proportion as the Y axis), uncheck the Uniform scale, adjust the Z axis back to 100%, slice plate, and print. Stringing may occur with Hueforge, just use a lighter to whisk them away.  

More prints: Bookmarks -- Portraits -- Coasters -- Clocks -- Puzzles -- Display Stands -- Display Frames

They are sorted and can be found in my Collections - https://makerworld.com/en/@3djd/collections