Stock Cam-Lock Lever Assy
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stock Cam-Lock Lever parts and Rear Clips for CR6-SE with build plate
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 14
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
These are stock Cam-Lock Lever parts and Rear Clips for the build plate on a CR6-SE.
I also have a set of printable stock Cam-Lock Levers with Pull Tabs, along with ones for adding a Flex Plate. You can find them here along more of my designs - https://www.printables.com/@DPs_Designs_4882792
PRINTING NOTES: Material: ABS Infill: 50 Speed:50-75 Adhesion: Skirt Supports: No
PRINTING POSITIONS:
Mounts - Rotate 90 degrees on side w/o supports. Or if your worried about structural strength leave upright w/ supports. Either way should work just fine for this.
Cam-Lock Levers - These could be rotated 90 degrees so they lay on the side of the arm for a little less support needed, but I find that printing straight upright gives just a slightly better result. Plus I had one of test prints fill the dip on the end of the arm with support, which was a pain to get out.
Clips - Rotate 90 degrees so they are on their sides.