D-Link DWP-1010 - Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A Stand designed for the D-Link DWP-1010 5G/LTE unit to let it stand on a flat surface.
Added hole for putting RJ45 cable through.
You need to take off both the light blue arm and the cover with the flat cable gland.
You can use the six M2.5x6 screws from the cover to mount the stand.
Printed in regular JAYO PETG, 0.4mm nozzle, 0.2mm layer.
IMPORTANT: You might want to cut the model and print the bottom 1-2mm layer first to test for dimensional compliance and then scale the model just a tiny bit accordingly to compensate for possible shrinkage depending on your filament of choice. I managed to screw into the 4 middle holes, the two outer ones are a bit too close (scaling up about 0.5-1.0% would probably solve that for PETG in my case)