1 / 3
Möbius Strip Sculpture – Infinite One-Sided Loop — zdjęcie 1
1 / 3

Möbius Strip Sculpture – Infinite One-Sided Loop

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A mind-boggling mathematical sculpture: the Möbius Strip has only one face and one edge, yet creates a full 3d shape.

Ocena
5 / 5
Polubienia
8
Pobrania
59
Wydruki
1
Wyświetlenia
155
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Sculptures
Licencja
Creative Commons — Attribution — Noncommercial

The Möbius strip is a fascinating surface with only one side and one continuous edge, created by taking a strip, twisting one end 180 degrees, and connecting it back to itself. Because of this half-twist, a path drawn along the surface eventually returns to its starting point after covering what would normally be considered both “sides” of the shape.

I have not printed it yet, so there might be errors; however, there are a few things you must do in any slicer software to prepare for printing:

  • Scale up to the right size for you(it initially loads very small)

  • Set the top, bottom, and wall layer thickness higher than usual(I set it to 1 mm to be safe) to make sure the whole shape has proper walls, and you cannot see the infill layer

  • Use a finer extrusion thickness, 0.1 mm, to ensure smoothness and fine detail

I hope you have fun trying to figure out the fascinating Möbius Strip shape.

Tagi