1 / 16
Aquila Bed Carriage & Fan for E3NG v1.2 — zdjęcie 1
1 / 16

Aquila Bed Carriage & Fan for E3NG v1.2

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Parts to use the Voxelab Aquila's Bed/Y-axis carriage for the Z-axis Gantry, Including a under-bed fan mount

Ocena
0 / 5
Polubienia
4
Pobrania
10
Wydruki
0
Wyświetlenia
233
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Printing

Use same settings as the rest of e3ng, parts should already be oriented correctly for printing

Drilling & Tapping

  1. Screw the guides to the carriage ensuring they're aligned properly using the built-in lip

  2. Use a drill bit the same size as the hole to make an indent in the plate for drilling

  3. Check that the indents are centered on the holes in the guide

  4. Remove the guides so the plate can be clamped down for drilling

  5. Clamp the plate down to your workbench with a sacrificial board in between. if you're using a drill press, clamp the plate to the drill press table if you don't clamp the plate down the drill bit can catch on the metal shavings spinning the entire plate violently, you risk serious injury by not clamping metal down for drilling

  6. Drill the holes aligning the bit to the indents you created

  7. Tap the holes using your preferred method

Assembly

For the most part, you can follow the e3ng build guide, however there are some changes and tips that  are helpful to know:

  • The orientation of the plate/carriage matters

For the proper clearances, you must orient the carriage as shown in this photo.

I originally mounted it differently which is why some of the photos show it flipped.

The issues you will run into by flipping it are:

  1. The gap between the front arms and the plate for adjustment wont be there

  2. The bed fan will hit the arms preventing it from being installed

  •  You may need to modify the strain relief mount

Since it wasn't that much work, i just uploaded a strain relief mount that fits

  • The bed fan uses M5 screws instead of M3

The original design used M3 heatset inserts and 3D printed filler pieces to mount the bed fan part.

My remixed design enlarges the holes and uses M5 screws instead, with no filler pieces and a washer in the back to fill the gap instead

Tagi