1 / 7
Makita RT700 Router – Wood Flattening Jig — zdjęcie 1
1 / 7

Makita RT700 Router – Wood Flattening Jig

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A Jig for flattening wood fitting for a Makita RT700

Ocena
0 / 5
Polubienia
5
Pobrania
24
Wydruki
0
Wyświetlenia
238
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Hi,

I’ve been using bamboo cutting boards in my kitchen for a long time. After extended use, they always become noticeably worn (cutting marks, bumps, …). To avoid throwing them away, I planned to mill them flat myself to make them smooth again.

My inspiration came from these videos:
https://www.youtube.com/watch?v=Jt71Lzc68kg
https://www.youtube.com/watch?v=pxAvGLkHtDQ

Since I already own a Makita RT700, I adapted the concept to the materials I had available.
All you need is an RT700, some M4 screws, and 2020 profiles.

Result:
The milling worked, but the result didn’t really meet my expectations.
There were very fine grooves on the milled surface (only noticeable by touch, not visible).

I’m not a woodworking expert, and unfortunately I don’t have a proper workshop; so I had to work on the kitchen floor. That, along with the lack of dust extraction, was probably the reason for the fine grooves in the cutting board after milling.

For now, I don’t have further need to work with it — I’m missing a good workshop.
I’ll just buy new cutting boards when I need one.

I’m uploading it here in case someone else can make use of it.

Print Settings

  • Layer height: 0.3 mm (0.4 mm nozzle)

  • Perimeters: 5

  • Infill: 20% gyroid

  • Solid layers: 3 top and 3 bottom

  • Supports: no

  • Material: PLA

Materials

  • printed parts

  • 4 system20 corner brackets (from here)

  • 4 countersunk screws (original from RT700 plate)

  • 4 countersunk screws M4x14 mm

  • 4 M4 heat inserts

  • 4 screws M4x12

  • 4 screws M4x8

  • 8 M4 washers

  • 4 M4 nuts

  • 4 M4 T‑slot nuts

  • some felt adhesive pads to reduce friction

  • 2 pieces of 1 m 2020 profile

  • some glide rails for the sides — I used 4040 profile

Happy printing & make the world a better place, one print at a time.

Tagi