Eufymake M5 Top Gantry Gridfinity shelf and bin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Gridfinity mount and a Bin with logo
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 42
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I liked the design of Sunlu's top mount, but I wanted to make it long enough to hold my dry box while I print. I also wanted to keep it within the Gridfinity system, so I sized it to the largest I could fit which was 6x3. You could probably even do 6x4 since it's pretty sturdy.
Another thing that I've been experimenting with was using inserts, so I added holes for m3 inserts as well as a bit more below it in case the screw to too long. I left it as 3mf so that you can resize the holes as needed, but m3 seems to be the perfect fit in the Gridfinity grid generator.
The top bin was just a generic 6x3x10 Gridfinity bin, but I jazzed it up with the logo inserts from some of the bins that I had found as well as cutting the top and changing the color. If I was to do it again, I would have made the side walls a bit thicker.
This was all printed on my Snapmaker U1 in ABS. I'm sure PETG would be fine, but I'm still a noob to 3d printing. No supports were needed. I figured if the insert holes were a bit off then it would get melted when I set the inserts anyways. Color and filament was Oveture ABS Green.
https://www.amazon.com/dp/B0BNQ6JHR2?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1