1 / 3
Hope Evo Brake to Shimano XTR shifter mount — zdjęcie 1
1 / 3

Hope Evo Brake to Shimano XTR shifter mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mount a Shimano XTR clamp type shifter directly to a hope brake leaver.

Ocena
0 / 5
Polubienia
3
Pobrania
11
Wydruki
0
Wyświetlenia
67
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

This adapter allows you to mount a Shimano XTR SL-M9100 clamp type shifter to a hope tech brake leaver. There is no need to buy a new I-Spec top cover or a complete shifter.

There is a short an a long version. It's only a few millimeters different, but noticeable. The long one is a bit easier to install. Chose whatever suits you best.

I printed in PETG and ASA. So far both worked well. But I would be interested if somebody tries PC.

Requires:

  • 2ea M2x10 screws flat head (brake disk screws will work)

  • 1ea Hope captive nut HBSP427N

Mounting:

  • Remove the original clamp with two screws. Keep the small one. Put the M5x10 and the clamp away.

  • Use a M5x10 screw to mount the leaver.

  • Reuse the M2.5 screw and run it directly into the adapter. Do not over torque it.

  • Install the hope captive nut to the brake leaver

Caution: Check that the screw for installation of the clamp has a sufficient length. Damage to the handlbar or brake clamp could occur.

  • Carefully tighten the adapter to the brake clamp. To reach the screw you woult need to press and hold the shift leaver one or two steps. This will move it away from the screw. Access to the screw head will still a bit limited. Avoid over torquing the screw. The adapter will break.

Printing:

The model requires support to print correctly. I recommend to add some additional perimeters. I used five. Torsional stiffness is not great. But not very much noticed during riding. 

Tagi