Centauri Carbon Canvas Rear Relocation

BONUS MOD FOR THE TINKERERS: I have added a bigger compression ring for the Tangle Detection. The bigger ring increases tension required for the Tangle Detection to trip in return allowing more friction to be permitted through the system. Also if using OpenCentauri Cosmos, I have updated Canvas configs with faster feed rates reducing the chance of high friction filaments not feeding properly. Please DM if interested.

New Part: Added a Baffle Slide for those who don't want to use HEPA filters.

EDIT AGAIN: Adjusted the top right mounting hole. Unfortunately due to the design their is now a void which requires the filter carrier/slide even as a blank. I'll work on a baffle version as well for those who don't want a HEPA filter.

EDIT: More Design changes made to Filament Guide as well as another guide "Filament Cube" for inside the printer, preventing the Print Head colliding with PTFE Tubes. This guide will require a bit of extra length in the tubing.

Centauri Carbon 1 Canvas Relocation

This is a relocation for the Elegoo Canvas on the Centauri Carbon 1. It features a mount including provision for a Filter and Filament Guide to suit. This utilities the pre-existing PTFE routing on the printer for the Canvas.

Through Testing, PLA has been the hardest to get work happily on my end. I have had better luck using PETG and ASA Filaments. TPU 95A also did work for one print I did. (Better results with OC Cosmos and bigger Compression Ring)

Files are uploaded as STEP, feel free to change and modify as needed to suit your needs and purposes :) Please Remix/Credit for any changes made public.

This requires extra PTFE Tubing and Hardware!

Built to receive this HEPA Filter carrier/slide.

My 150mm Riser (In photos)

I recommend the Funnels as they help to load filament.

Canvas Mount

• The Canvas is to be mounted before being mounted to the Printer.

• M3x8 Button Heads where "Longer Screws Required" (Counter bores are 2mm on the model) 

Filament Guide and Setup.

• Required 4 roughly 50cm tubing

• I recommend the PTFE tubes to be routed prior to attaching to the Printer and Canvas.

• Allow extra length so tubing can be adjusted accordingly.

• Please reference the picture below when routing PTFE tubes as orientation matters ( 1 goes to 1 on canvas, 2 to 2 etc).

• For tubes 2 and 3, please allow extra length as below, as this helps with the Filament guiding itself. Adjust accordingly.

• When connecting the Guide to the Canvas Holder I just used 2 M3x10 (M3x12 works as well) Button Head screws and let them Self Tap until secure.

• Reuse the middle screw in the spool holder.

• Adjust spool mounts accordingly | 1 - Top Left | 2 - Top Right | 3 - Bottom Right | 4 - Bottom Left |

Using 4x 100cm tubes, now route to print head  through original PTFE tube, Adjust and cut to length accordingly allowing full unrestricted movement of the print head. Make sure to route through the Filament Cube to prevent Print Head colliding with Tubing.

The cable chain sits inside the cube and then the PTFE Tubing. Reuse Cable Chain Hardware

Tangle Detection Compression Ring Upgrade

For those who want to do this. You firstly have to disassemble the Filament Hub. Once that is done, you swap out the silver Compression Ring above the spring for the bigger Compression Ring (These can be changed to varying heights for different tensions. I have used ASA, PETG Minimum. Once the ring is replaced, reassemble and reinstall the Filament Hub.

Credit to OpenCentauri Team for the photo.

Any issues regarding the models and post, please notify me.

Files are uploaded as STEP, feel free to change and modify as needed to suit your needs and purposes :) Please Remix/Credit for any changes made public.