Push fit Moderator/Silencer for Weihrauch HW35
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Push fit Moderator/Silencer for 15mm barrel air rifles with cutout for foresights
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 192
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I have adapted this .22 Silencer/Moderator by "elseb" to a push fit that fits perfectly on a Weirauch HW35 air rifle, however it should fit any 15mm barrel. If there is any interest i can make a version that can be tightened with a bolt if you dont have foresights to ensure it stays in place. Although the push fit is fairly tight.
Prints mostly without supports apart from the very top where the cutout is, just support paint that part and you're good to go
I have printed mine with PLA and ABS, perfect fit, however i havent fired the gun with it yet as its currently 1am.. i will update in the morning.
[UPDATE] SOLID PLA or PETG will work, 40 shots and still going. 3 wall PLA broke after a few shots, ABS was too tight. So TPU or solid PLA/PETG is the way to go for these.
[UPDATE 2] TPU works perfectly! Might want to go for a more stiff TPU. I used 85a because its what i had but it works good.
For those with the HW35, loosen the screw of the foresight and remove, slide the moderator on until the barrel reaches the cutout, put foresight in the cutout aligned with the rails on the barrel then push both the moderator and forsight back together, unsuring the foresight is in its rails, tighten screw.