Infinity Mirror Keyholder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a keyholder that reminds you to take the keys before you go out, in a decorative way. Requires electronics skill
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 47
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I have seen an example of this on the internet and decided to make something similar.
The main body and top cover can be scaled up if you need to make it bigger, just make sure the rest is printed on actual sizes or it wont fit as expected. If you scale up, you will also need to cut the mirrors on correct sizes.
IMPORTANT NOTE: Requires basic electronics and soldering skills. Without the sensors and light, the infinity mirror setup won't work. Note that even LED lights create heat. This is designed to work in a short duration without creating much heat. If you remove the circuitry to make it "always on" it will heat up and potentially become dangerous, not to mention the battery drain quickly (hours instead of weeks)
100% tested, but user feedbacks are appreciated to make this better.
Print with PLA 100% infill. Check the documentation for instructions.
Finishing: Use a filler primer to remove layer lines. Use spray paint to paint, and Lacquer (clear, gloss) is advised for a nice finish. Do the paintwork and make sure the paint is dried before assembling.