Beeline Moto 2 Triumph Bonneville T120 mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My attempt at a custom mount for the Beeline Moto 2.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 257
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wasn't a fan of the rubber-band handlebar mount solution. It works, but it feels a tad cheap considering the cost of the Beeline. I also wanted to use the charging adaptor so I don't need to worry about battery level. This print better fits the aesthetics of the dash and also places the Beeline in an easier-to-see position for at-a-glance navigation.
You'll need to print the ChargeMount, Bracket, and x2 Spacers.
The original bracket was too thin and flimsy, so v2 has extra thickness via ribs for added rigidity. It's still not perfect, in my opinion — laser-cut aluminium would do a much better job. Unless anyone can remix a better solution! (I'm still very much a beginner designer, and structural stuff isn't my forte.)
Also, v2 of the ChargeMount increases the total height by 10mm and brings the top of the Beeline level with the top of the speedo dials.
Hardware required;
x3 M4x6x6 Heatset inserts
x2 M5x16 Button head screws
x2 M4 Socket head screws (I think I used 12mm, but 10mm would also be fine)