1 / 6
Blackout Curtain Holder that minimize bleed of Daylight — zdjęcie 1
1 / 6

Blackout Curtain Holder that minimize bleed of Daylight

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A easy-to-use curtain holder to minimize bleed of daylight to black-out a bedroom. No drilling, easy installation.

Ocena
0 / 5
Polubienia
0
Pobrania
5
Wydruki
0
Wyświetlenia
48
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Ultimate Blackout Curtain Holder

Pictures on the cover photo were taken with exactly the same camera settings.

This curtain holder is designed to reduce the bleed of daylight into a bedroom by pulling the sides of the curtain close to the wall. It is very easy to use, the conical part is attached to the curtain and is easily slid into the hull part, which is mounted to the wall. All parts hide behind the curtain and are not visible from upfront.

There is different variants of the hull with different angles for the slit, which results in different angles of tilt for the curtain. A steeper angle tugs the curtain closer to the wall. I am using a 20° angle.

We only installed a single holder on each side of the curtains, depending on your setup you might want to install two or more per side to keep the curtain aligned with the wall from top to bottom.

Installation

Parts:

  • 2x curtain_holder_cone

  • 1x curtain_holder_hull_??deg_right (pick a variant with the angle that fits your situation)

  • 1x curtain_holder_hull_??deg_left (pick a variant with the angle that fits your situation)

  • Double-sided tape

  • Thread in similar color to the curtain

  • Needle

  • (Optional) 2x Cylindrical Magnets, 6mm Diameter, 2mm Height - Not needed

Instructions:

  1. Print the parts.

  2. (Optional) If you want to, install the magnets by press-fitting them into the holes on all parts.

  3. Find a good position on the curtain to mount the holder. I went with 20cm from the top, 5cm from the side. Take-off the curtains.

  4. Attach the curtain_holder_cone part to the curtain by sewing it on.
    This can be made easier by applying a bit of adhesive (tape or glue) to the printed part to hold it in place against the curtain.
    Sew it on from the backside, making stitches within each of the holes:

    Follow the following pattern on each side:

  5. When the holder is installed, install the curtain again.

  6. Attach double-sided tape to the backside of the hull part.

  7. Insert the hull part to the cone on the curtain, check the position against the wall, and mount against the wall.

Usage

Simply drop the cone into the hull. I usually just grab the curtain from the front and drop it in blindly. To get it out again, just slightly pull-up the curtain!

Printing

Prints easily with PLA and without supports. Should also print without infill, material inside the cone is removed by design. Make sure to use the right orientation with the flat surface facing down.