Low Friction Wall-Mounted Spool Holder (single and MMU3 set)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A set of low friction spool holders for 1-N filament reels: * 200 diameter * 70mm wide
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 95
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Notes
Printing set is laid out to support 5 reels by default:
SpoolHolderReel-Set - this is a set of five axles and bobbins
SpoolHolderBrackets-16 - this is a pair of end brackets
SpoolHolderBrackets-23 - this is a pair of internal (left side) brackets
SpoolHolderBrackets-34 - this is a pair of internal (right side) brackets
If printing just one standalone spool holder, print SpoolHolderBrackets-16 and SpoolHolderReel-Single
If printing more than 5 reels worth, print as many additional Brackets-23 (left side) and Brackets-45 (right side) as you want, and of course additional SpoolHolderReel-Single.
Required Parts
The set requires:
18-off No. 8 Screws (4mm, flat head)
10-off 608ZZ bearings
Printing
Recommended 3D honeycomb fill for brackets - 10%
Recommend bed supports for axles
Bobbin / bearing assembly:
Push one bearing into the bobbin so that it is flush
Push axle through from other side
Push bearing onto axle from other side until flush with bobbin
Note: there is 1mm internal clearance - axle will move freely - if there is too much friction - push on end of axle so that bearing on other side is flush with the bobbin - if there is too little friction, push the bearing in.
Attribution
When providing attribution, please ensure a link to https://www.vizier.uk/gd is included.
Guide Dogs for the Blind
This model is provided free, however it would be appreciated if you would consider making a donation to Guide Dogs for the Blind, using the link below.