Senku's Turret Revolver
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replica of the turret revolver made by Senku during the Treasure Island arc.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 89
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Replica of the turret revolver made by Senku during the Treasure Island arc.
Can be printed with empty chambers as shown or with "loaded" chambers.
Can be assembled using included pins OR M4 screws of equivalent length.
Unlike most of my models, it is recommended to glue a few places: the 2 halves of the top rib, the pump bar to the pump, the barrel to the frame and the turret top to the cylinders. This is especially important if you intend to do cosplay with it.
Recommend printing the following with 99 walls for strength: rib halves, frame, trigger, firing pin, push rod, rear trunion. Everything else should be fine with 2 walls 15% infill.
I do recommend replacing the printed bolt for the central assembly with an actual M4x30 bolt.
Category: Props
UPDATE 5/31/2026 - Corrected a duplicate in the files. Please redownload both pump and pumpslide stls.