1 / 1
Razer Blackshark V3 X Hyperspeed earpad spacer — zdjęcie 1

Razer Blackshark V3 X Hyperspeed earpad spacer

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This spacer creates more room for your ears so they don't scratch on the inside of the headset.

Ocena
0 / 5
Polubienia
0
Pobrania
13
Wydruki
0
Wyświetlenia
115
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Please read this first!

No Pictures for now, I'll add them when I have the time.

Do this at your own risk.

The spacer is split into 3 pats, which are hold together by friction. You need to remove the earpad and unscrew the speaker from its housing in order to attach the Outer Ring (Be careful to not destroy the wire that is attached to the speaker and the shell). The Outer Ring is open on one end. Slide it behind the speaker and around the wire with the open end pointing down. The Outer Ring will sit in the slit with the small ribs, It might require some bending to get it into place. Hold it in place with one hand, pull the open end out and push it over the other open end so it snaps together. Once in place, screw the speaker back into the housing. Now just press the Spacer into the Outer Ring (The Spacer has a slight angle to it, make sure the wider part is pressed into the Outer Ring first). Do the same with the Inner Ring. Make sure they are pressed down all the way. To get the earpad back on, align the seam with the seam of the Outer Ring and carefully use your finger from the inside of the pad to stretch it over the edge of the print. Check if the plastic piece in the earpad is twisted.

Tagi