Enclosure for EC Buying YR-1001 12v dc fan controller board
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Snap together enclosure for the EC Buying YR-1001 Fan Speed Control Board
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 59
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a 3 piece model for the EC Buying YR1001 Fan control board.
Available thru Amazon, AliExpress, Alibaba, etc for just a few dollars.
I used PETG, you can print it without supports but the faceplate will turn out slightly better if you print it with supports. Pop the board in and press down, place the button strip in the faceplate, noting that two of the buttons are slightly wider apart, so be sure to orient the strip correctly. Then just GENTLY press the faceplate into place. This works best if the print is still warm as it is a press fit.
The hole in the back can be used to mount it, and you can just trim the side tabs off.
It's also there to pop out the board if it needs to be replaced.
Just remember the connector by the display is power input, the connector by the buttons is sensor input.
Print time is about 70-80 minutes depending on your print settings.