1 / 7
Creality K1 Max Fume & Heat Extraction System (EU/Swedish 250 mm Vent Standard) — zdjęcie 1
1 / 7

Creality K1 Max Fume & Heat Extraction System (EU/Swedish 250 mm Vent Standard)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Complete K1 Max to 100mm hose exhaust kit. Features a three prong slide-on hook adapter for 250mm EU/SE ceiling vents.

Ocena
0 / 5
Polubienia
7
Pobrania
18
Wydruki
0
Wyświetlenia
184
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Share Alike

Summary

This is a complete, two-part 3D-printable ventilation kit designed to vent heat, microplastics, and VOCs from your Creality K1 Max directly into a standard room exhaust valve. The system bridges your printer to a standard 100mm flexible ventilation tube (vinyl or aluminum spiral ducting) and routes it cleanly to the ceiling.

Dual-Action Negative Pressure Design

This setup mimics the airflow principles used in commercial drying cabinets. By utilizing a wide 250mm funnel with an air gap at the ceiling, the system draws out high-temperature printer exhaust while simultaneously drafting ambient room air. This creates a passive negative pressure loop inside the hose, completely eliminating back-pressure on the printer’s internal fan and preventing dangerous VOC leaks into your workspace.
Printer enclousure fan is not needed to run, also keeps closed chamber ventilated properly for PLA.


Kit Components

1. K1 Max Exhaust Adapter (Printer Side)

  • Mounts directly over the rear exhaust fan port of the Creality K1 Max.

  • Features integrated deep ridges to firmly grip and seal 100mm spiral ducting without slipping.

  • Square base design handles high-speed printing vibrations without coming loose.

2. Slide-On Ceiling Funnel Adapter (Vent Side)

  • Designed explicitly for standard circular residential/commercial ventilation valves common in Sweden and the EU.

  • Adapts the 100mm hose up to a wide 250mm collection funnel.

  • No-Demolition Install: Features three integrated mounting hooks. It simply slides in from the side over the lip of your existing ceiling vent. You do not need to unscrew or remove your ceiling hardware.


Print Settings

Part

Material

Orientation

Supports

Walls

Infill

K1 Max Adapter

PETG / PLA

Flat square base down

Optional for internal corners. Bridging should also work.

3

15%

Ceiling Funnel

PETG / PLA

Narrow funnel base down, add brim in/outside

None

4

15%

Tagi