Sausage stuffer pusher
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a set of pushers with a handle and push rod to clear out sausage horns. The handle needs to be glued together.
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 76
- Wydruki
- 0
- Wyświetlenia
- 822
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
4-piece sausage stuffing horn pusher. I made this to clear my set of sausage horns after stuffing into casings. The end caps measure just under the diameter of the set of horns that I own - 10mm, 13.5mm, 17.5mm, 21.5mm.
Only the two handle halves need to be glued - that way everything can be stored in a more compact fashion and easier cleaning.
You can either print two small pins, but I used 1.6mm (width) brad nails cut to 14mm long for strength, then glued using super glue.
When looking at the STLs, the inside cylinders are negative space to allow the rod to connect to the end caps.