1 / 5
Tumble Dryer Vent/ adaptor for solar cables to enter house. — zdjęcie 1
1 / 5

Tumble Dryer Vent/ adaptor for solar cables to enter house.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adaptor to allow you to put solar cables through a wall using a disused tumble dryer vent.

Ocena
0 / 5
Polubienia
0
Pobrania
4
Wydruki
0
Wyświetlenia
41
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

Put a small backyard solar install in my garden on fences and a shed. Needed a way to get cables through the wall, I'd already decided I was going to use a 2kw Ecoflow battery to run my heatpump tumble dryer, the heat pump tumble dryer also meant I had a disused dryer vent which was 150mm x 150mm on the outside (I think a 100mm duct). So I pushed the cables through to the battery on the other side of the wall and temporarily taped it up with Gorrilla Tape, as a longer term solution, I decided to make a simple cover to A, tidy up the tape and B, allow me to seal the vent up a bit better (Ironically still using gorilla tape, but much tidier).

The version I printed uses files 2 and 3 printed in 85 shore hardness black TPU (thermal polyurethane) for flexibility and parts 4 and in black PETG for durability and weather proofing.

My support settings aren't great at the moment on my printer using PETG, so I didn't print it all in one go, otherwise I would have used part 1 in PETG all in one go.

I used joiners mitre glue and kicker (superglue) to attach part 4 to part 5, after trimming the openings of those parts with a Rotary/ Dremel sanding head for a tight but reasonable fit.

Marked the positions of the screw holes on the wall using a screw to leave a scratch, drilled a 5mm hole, used some yellow Rawl plugs and some 65mm long by 4dia outdoor screws. (you may need a long drill bit to get around the right hand box).

Then pushed parts 2 and 3 into place ensuring the double seals were tight, You could use superglue here or just friction fit if your tolerances are good enough, the hole is big enough to support a good number of cables, I've put 6x 6mm cables through and just sealed it up with black Gorilla tape to ensure mice cant get in easily. This tape may need replacing from time to time but shouldn't be a problem.

*Obligatory common sense safety announcement*

If you use, this please ensure that you are using a completely disused vent and that there are no fans or appliances on the other side of the wall that could foul up the cables and that everything fitted is well sealed up so pests can't find a way into your house.

Also please pre-measure the dimensions of your vent if you are using this, if it is only out by a mm or two you can probably just scale all the components up or down to match.

Tagi