Virtu / V-ION EBB36 v1.2 mount for 5015 - beta
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Oof, she's a tight fit. 5015 mount for EBB36 v1.2 toolhead board.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 125
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Oof, she's a tight fit.
5015 mount for EBB36 v1.2 toolhead board.
Additional BOM: 2 more M3 heatsets and 2 x M3x8
To make it workable, fan has been shifted back by just over 3mm. The Y endstop needs to come forward a few mm to compensate and the duct makes up the trio.
Its tight... and I really mean that. It could be less tight if you wanted to sacrifice more of the bed.
You will be spending a lot of time planning out your wiring. Duponts will not fit on anything that sits behind the stepper motor. Requires a 17mm thick NEMA14 pancake. Anything thicker and you've got no chance
Only partially compatible with AWD front cooling - use 10mm fans and BHCS for these and you will only lose maybe 5mm at the front. Trim some of the fins on the stepper driver heatsink and you can get this number down lower.
Probably not compatible with SHT36 V2 without swapping out the pins on the weird fan mosfet daughterboard for right angle ones.
For suresies not compatible with SHT36 V3 or EBB36 gen 2 - those will both need an increase to the height of the cable support which I haven't done yet. If someone wants to gift me one for testing reasons I won't say no!