A9 Mini Camera Housing (NO PORT CUTOUTS)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Custom solid enclosure for the A9 Mini camera without any port cutouts or holes.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 70
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
📷 About this model This is a custom modification of the A9 Mini Camera housing. Unlike the original, this version is completely solid and has no port cutouts or cable holes. It is ideal if you want to: Customize and drill your own connector holes exactly where you need them. Use the camera in environments where you need extra dust protection. * Create a clean, stealthy look.
🖨 Recommended Print Settings For the best results, use these settings in your slicer: * Material: PLA, PETG, or ABS (PETG/ABS is recommended for outdoor or warm environments). * Layer Height: 0.2 mm (or 0.16 mm for smoother curves). * Infill: 15% - 20% (Gyroid or Grid). * Wall Loops / Perimeters: 3 (for extra strength if you plan to drill holes later). * Supports: YES (Depending on your printer's bridging capability).
🛠 Post-Processing If you plan to make custom cutouts, it is recommended to drill carefully at low speeds to prevent the plastic from melting or cracking.
«The lid might be a bit too small for the body; you may need to scale it up slightly in your slicer. I will fix this model and upload an updated version later.»