PC Case Gamdias Aura GC1 replacement Side Panel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed a travel side panel to replace the glass panel when I go on trips. This panel replaces the glass panel.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 68
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
I needed a 429mm long x 305mm wide x 4mm thick side panel to replace the glass side panel on my Gamdias Aura GC1 PC Case since glass doesn't travel well and may break in transit. I needed 4 pieces with dovetail joints since I have a X1C and it was too big for the print bed. Use Epoxy to join the 4 panels, not superglue (too brittle). On the chance this might fit other PC Cases, I did not put in the screw holes. You can drill them yourself. I used Transparent Red PETG and Black PETG with a solid red back (2 bottom layers) and set top layers to Zero so the infill (cubic) would show as a design. This way, one may choose to mount the side panel either side facing out. As an added bonus, you can print something and glue it to the side panel. I plan on glueing a Sith Lord design to the outside panel and have lights shine through the cubic infill patterned Transparent Red PETG for a nice effect.