Omphobby M4 Max Landing skid
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A direct replacement part for the Omphobby RC Helicopter.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 93
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
When I crashed my M4 Max, I broke the original landing skid which - again - wasn't on stock at my local supplier. Fortunately I found this https://www.printables.com/model/1345426-omphobby-m4-m4-max-landing-skid-updated-version to keep it flying, but I did not like the look of the skids and the canopy didn't fit over it. So I decided to make a complete redesign, just like I did for my M2 V3 Pro.
The landing skid has the same look as the other heli's of the OMP family, although the M4 frame is still slightly tilted forward to clear the tail rotor from the ground. I modified the way the canopy clips in at the bottom, so you don't need the original bracket (I think this solution actually works better). The canopy fits without modification so it is 100% exchangeable. You can reuse the same bolts to fix it.
I printed this using the "Balanced 0,2 mm"preset with PLA (green) and PC Blend (orange), both print and work fine. For easier cleanup I blocked the supports just above the clips, but that is not required.