1 / 1
Sunlu Filament Drier S1 Plus pass thru to Bowden Tube — zdjęcie 1

Sunlu Filament Drier S1 Plus pass thru to Bowden Tube

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Allows connection of a bowden tube to the Sunlu S1 Plus Filament Drier

Ocena
0 / 5
Polubienia
2
Pobrania
6
Wydruki
0
Wyświetlenia
96
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Public Domain

Allows connection of a bowden tube to the Sunlu S1 Plus Filament Drier

Parts and Tools needed:

  1. (2) M3x10mm screws, SHCS or BHCS (i would recommend BHCS, i just didn't have any in stock)

  2. (2) M3 nuts

  3. allen wrench for m3 screw

  4. 5.5mm wrench for M3 nut

  5. 1.5mm Drill Bit

  6. 3mm drill bit

  7. 2mm drill bit

  8. M6 threaded Bowden tube connector

  9. 10mm wrench or crescent wrench for bowden tube connector

I printed at 0.16mm layer height with 3 walls and 4 layers top and bottom out of petg, worked good for me.

Use picture for reference.

  1. Unplug the drier.

  2. Place the bottom of the drill guide an inch or so above the bottom of the clear case. The top has the rounded edges, the bottom is square. (i free handed the placement you can tape it in place if you don't have steady hands ).

  3. Center it and mark the top hole with a sharpie or something similar.

  4. Use a pilot drill bit (think mine was 1.5mm) in the center of the mark to make a pilot hole

  5. Then a 3mm drill bit to open up the hole.

  6. Put first m3 screw and nut in the top hole and hand tighten the drill guide in place

  7.  Vertically align the top and bottom hole and mark the bottom hole with a sharpie

  8. Swing the guide out of the way and drill pilot hole

  9. Use 3mm drill bit to open up the hole.

  10. Place second m3 screw and nut in the bottom hole and hand tighten.

  11. Use 2mm drill bit and drill through the 2mm hole in the center of the drill guide. The hole is at an angle so you will need to drill at an angle.

  12.  Remove screws and drill guide and clean up the areas around the hole of any plastic debris

  13. Put the Filament Pass through piece up on the drier and attach with the m3 screws and nuts and use the 5.5mm wrench to tighten. Don't overtighten it and crack the plastic. that goes for all parts here. you have been warned!

  14. Screw the M6 threaded bowden connector in and tighten until the fitting touches the plastic with the 10mm wrench (or crescent wrench, 10mm wrench highly suggested though).

  15. Clean up any plastic inside the drier.

Now you should be able to attach your bowden tube and run your filament through.

Happy printing.

Tagi