Double Lynx - Blynx

Quick and dirty double Lynx.

Hardware:

• 2 sets of Lynx hardware

• 2 sets of Nekomata hardware (optional, not strictly necessary for operation outside of the 2.1 tensioner)

• 2-6 m4 pins for the pump coupler (optional, may be printable)

• 60mm 3/32" pin

• 2 2.5x15mm+ screws for the sear (optional, easier to assemble)

• 2 pieces of 788 cut to around 7.5"/190mm or worker style springs under 1.5mm in wire diameter (for extended draw internals, strongly recommended for above ~180)

Print Notes:

Use supports on the trigger area of the receiver.

Make sure your X-Y hole compensation on the triggers are dialed in to minimize slop while letting them rotate freely on the pin. This will vary depending on the number of walls and filament.

Use the same parts as a regular build for everything not listed.

Other Notes:

Left slots for Foamgasm thumb releases available if you wish to edit the levers to make them accessible at this width.

Strongly recommend using Hijinx or Kunlynx internals to make this usable at 200+. I personally run Kunlynx pumps and get ~220 out of both barrels with a comparable prime to a 1.6 spring harrier. A cut down OOD 1.4 swift/mk4/npx spring or the OOD 1.4x250 with 40cm of vorpal gets me there around the limits of what is comfortable to repeatedly prime. OOD 1.45x250 hits right around 250 but is just not reasonable for my noodle arms.