Invincible Action Figure - Print In Place - Articulated
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fully articulated print in place Action Figure
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 113
- Wydruki
- 1
- Wyświetlenia
- 548
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Action Figures & Statues
- Licencja
- Creative Commons — Attribution — Share Alike
I've been watching a lot of Invincible so I figured I would try my hand at making an action figure. The pictures are printed with a .2 layer height with cura on an Ender 3 v2. If you have a stronger machine you can go as far in detail as .08mm. These figures are articulated like the old 3.75inch GI Joes. This guy prints at 3.75in tall and takes about 3.5 hours on the Ender 3v2. Still retains articulation with PLA+ but I'm sure would be better with PETG.
0.2 mm layer height- .08mm layer height
Wall Loops: 3
Enable Support
Support on build plate only!
Disable Remove small overhangs