Donkey Kong inspired marble run

       Bring a classic arcade moment to life with this Donkey Kong–inspired marble run, designed to look and feel like the original game, but with marbles racing down the ramps instead of DK’s barrels. The result is a playful display piece that also, to my knowledge, works with 10mm marbles, (untested with larger)

       Credit where credit is due:

The peach figure was made by DonJakobo: https://www.printables.com/model/50090-princess-peach-statue

and the DK by austin simon:https://www.printables.com/model/848764-donkey-kong

       It's important to note that I only had time to print the first iteration due to a contest deadline. This iteration did not work; the marbles accelerated too quickly. I modified the design for long ramps and slower acceleration. I tested it in a physics engine, and it work fine, but beware, it is still untested in the real world. PLEASE GIVE FEEDBACK!

       Anyway, back to the print. It's a big one. It is about 247mm tall, 241mm long, and 98mm wide. It was a tight fit on my P1S (256mm, 256mm, 256mm build area) It also requires a lot of supports. Be careful when removing them, I accidently took off DK's foot! The best way I found to print it was like this: 

My print settings were as follows:

• 10% infill, gyroid

• 2 wall loops

• tree supports

• .2 layer height

• about 11h and 40 minutes on Bambu Labs P1S

That's about it, happy printing :)