Portable Molle Drill Bit Holder (latching)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This drill bit holder holds bits from 10mm to 1mm securely and low-profile on a molle-style loop panel
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 37
- Wydruki
- 1
- Wyświetlenia
- 168
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This drill-bit holder holds a 19pcs set of drill bits securely and low-profile and is designed to clip onto a molle-style loop surface. The latch (orange) prevents the bits from falling out.
Hardware
2x3mm x 40mm pins (for hinge)Foam tape (optional)
Printing notes
You should probably use supports on the long bridge for the lower latch rail on the base case, other than that, can be printed without supports. You will probably also need to sand/carve a bit for the pin holes or the sliding latch so that it works well, this depends on your printer/material tolerances.
Notes
I used foam tape on the bottom of the lid to prevent clacking of bits, and used a marker to label the bits. With a multicolor printer, this could also be printed directly into the design.
This is designed to fit on the top panel onto the loop surface inside a "TT Multipurpose Pouch VL" (Link) and is sized for these Bosch drill bits (Link).