Bobble Ended KeyManager Key and Access Pegs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two replacement pegs as used on KeyManager key board.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 32
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
I needed to replace some broken/worn access pegs for a Key Manager board. These are the bobble ended versions. 2 files.
The one with the plain end is used to hold the keys and the one with the gear is used to unlock and remove the keys.
These were printed in an upright position on an Ender 5 printer and for maximum layer adhesion they need to be printed solid on a slower speed. I found that printing one peg at a time with a raft base and supports was reliable using PETG.
Due to the fact that the keys might be left in a hot vehicle suggest PETG over PLA. Depending upon the printer used you may need to adjust the print scaling. On my Ender 5 I used 99% scaling when printing.