EJEAS V6 Pro+ mount for HJC Helmet

Mount for the EJEAS V6 Pro / Pro+ Intercom. Replaces the existing battery cover of the helmet, you can reuse the same screws that come with the original battery cover.

I recommend printing it in PETG or better, I wouldn't trust PLA for this.

On Orca Slicer, if you auto-orient the object it will place it like this:

I really like that orientation because the print lines orientation should make the clip stronger in all axis. Unfortunately, when trying to print it, the surface area of contact of the object with the bed is too little, and it falls down, even having set up a brim, supports and on a CoreXY.

I had to print it like this:

Which went ok, although i had to sand the intercom clip part of the model, so it slides easier.

(Small note: if you print it like this, flip it 180deg, so the bump of the ejeas clip is up instead of down, that way it's not as annoying to sand)

If you have ideas on how to make the design better, please tell me! For starters I know it's a bit too annoying to print, and I also was thinking that it'd be cool to include to route / hold the cable that goes to the headphones and mic. HMU if you're interested and I could review the design, or of course, you're welcome to do a Remix!