2.5 Gen Toyota Tacoma Radio Shelf
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Shelf/glare reducing visor for the 2012-2015 Toyota Tacoma
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 217
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
4 September '26: I'm having an issue with the weight/heat disagreeing with the tape and losing adhesion. So I made a version of the original without the ball and another version with a deeper pocket. So if you download the version with the ball and have issues with it staying on, you can't say I didn't warn you.
18 July '26: To everyone who downloaded the original, I must apologize. I have updated the model to the current version that I have been running in the truck since 19 June '26. I wanted to test it before putting it back out there. After a month of use and some bouncing around on a trail to abuse it, I'm confident enough to release it. I added an extruded hole up through the post and ball, so when printing it adds additional walls to where the original broke. I would recommend using stronger tape than I have for best adhesion. You can see why in the 2nd to last picture. I would also recommend adding something to keep from rubbing at the bottom of the side support.
Add a place to mount your B size (1in/25.4mm) phone mount above the radio and also reduce glare on the screen. And the best part... no drilling! It is attached above the radio, to the bezel with 3M double sided mounting tape. This is for the 2012-2015 (facelift 2nd gen) Tacoma. I'm sure it will fit the pre-facelift 5th gen 4Runners as well, but I have not verified. If anyone would like to try it and let me know if it works, I will update this post.
I printed in ABS, although ASA will probably be a better choice as this is designed to see a lot of UV exposure.
My Print Settings (outside of Elegoo Slicer .16mm PolyLite ABS preset):
Setting | Selection |
|---|---|
Seam Position | Aligned Back |
Ironing Type | All Top Surfaces |
Ironing Pattern | Concentric |
Ironing Line Spacing | 0.1mm |
Wall Loops | 3 |
Sparce Infill Pattern | Cubic |
Enable Support | On |
Type | Tree (auto) |
Tip Diameter | 3 |
Tree Support Branch Diameter | 4 |
Fuzzy Skin Noise Type | Voronoi |
FUZZY SKIN NOT NEEDED. But I like how it takes up the dead space in the pocket and it makes it a little less bland. I used the fuzzy skin painter to cover the exterior sides and the middle of the pocket.
