1 / 2
Back cover/endpiece for a Meanwell LRS-350-24, LRS-200-24 on a Creality CR-10v3,Ender3V2 — zdjęcie 1
1 / 2

Back cover/endpiece for a Meanwell LRS-350-24, LRS-200-24 on a Creality CR-10v3,Ender3V2

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Back cover/endpiece for a Meanwell LRS-350-24, LRS-200-24 on a Creality CR-10v3,Ender3V2

Ocena
0 / 5
Polubienia
1
Pobrania
10
Wydruki
0
Wyświetlenia
52
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Original model is great, but I wanted to use fine thread screws for the tapered screws to hold in the mains power.  I drilled hole to get around this.  Since I had an LRS-200-24 pulled from a Voron build (PSU was upgraded) I needed another test PSU.  

I added a second model with tighter tolerances for the rocker switch

The angle was changed 45 degrees to print with less support on the inside.

Lastly, a hole was added to the bottom so if fine thread tapered screws were used needle nose plyers could hold a nut/nylock.

Print with support for the over hangs.

If creating one of these without the parts from a CR10 or Ender the mains power connector is IEC320 C14, and rocker switch is 14x30mm and is 10mm wide.