1 / 4
Nikon Coolscan carrier / holder for 126 kodak instamatic film in MA-21 slide scanner. — zdjęcie 1
1 / 4

Nikon Coolscan carrier / holder for 126 kodak instamatic film in MA-21 slide scanner.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Nikon Coolscan carrier / holder for 126 kodak instamatic film in MA-21 slide scanner.

Ocena
5 / 5
Polubienia
3
Pobrania
26
Wydruki
0
Wyświetlenia
132
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
GNU General Public License v3.0
  1. Does not need any opening/dismantling/cutting of original holder, as per original linked instructions! (see below). Fits around internals, see pic.

  2. Can scan first two one way around, then spin 180 degrees and scan the last two. Tops stays top.
    (If you have a fifth frame you can just adjust film positioning in the carrier and have it hang out at either end, there is space inside for it. Nearly all mine were x3 or x4 strips.)

  3. Tolerances tightened slightly so it doesn't wobble and should make slides perpendicular.



    Old Info
    ----------
    Paal's link here just for the record.…now on waybackwhen machine.

    https://web.archive.org/web/20240714153604/https://www.camerahacker.com/Forums/Film%20Camera/APS/Scanning_APS_Film_-_Nikon_IA-20_Problems.files.hidden/Film%20Holder.pdf

    The best bit from above is ;
    “Note: This tab appears to serve no useful function. MA-21 will function perfectly with this tab removed.”

    …A few seconds of fiddling can see what it does, it stops the eject shaft popping up and over the white eject arm! Not cutty cutty thanks.



    Other Notes
    ---------------
    Works ok without magnets as the plastic spring clips keep it together enough inside, I have some on order just out of interest, as super cheap on Aliexpress….

    If things don't ‘fit’ easily your printer probably is extruding too much and needs calibrating,  e.g. my Ender pro , slicer set flow at 95% is correct. (Unless yours is miles out there is still enough tolerance to be fine.)

    If you intend to remix/adjust, the OpenSCAD (.scad) is just one model, the top or bottom output picked by menu on the right. (holder > part). It has been fiddled with a lot and is a bit of a dogs dinner!

    The Nikon software gives better results than Vuescan imho, pic below of my rough notes if it helps someone...can't be bothered tying them nicely here, OpenSCAD drained all my effort...
    (Running it in Win7 on a VM in Ubuntu)