Shoelace connecter clips >2 hour
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are clips to connect your shoelaces together, so you don't have to tie them.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 227
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
These are clips to connect your shoelaces together, so you don't have to tie them. These clips are in their ideal printing position and are ideally printed in PETG for longevity. The first folder has screw-based clips. To assemble thread the lace while it is connected to the shoe through the thin section of the thick threaded rod and then pull all the way through. Then put your foot in pull both laces tight until comfortable and put a knot in the lace as close to the hole in the threaded rod as possible. Next cut the lace close to the knot and repeat for both laces. Finally, screw on the hexagonal bolts and repeat for both shoes and enjoy.
If you don't want to work with screws, there is a ball joint version, but these other clips require short laces with a full aglet (the little plastic part on the end. You can measure your aglet with a pair of calipers (or a ruler) to find your aglet size.
Warning: these mods are semi permeant, and the laces can be hard to remove from the holders and once cut cannot be used on other shoes.