NanoMini (For Nerf NanoFire)

Uses only 1.75mm Filament as hardware, the NanoMag platform started out just as a way to take advantage of the nub at the end of the Nerf NanoFire. It eventually expanded into a magazine system not shown here, this is the shortened version of it that I am providing for free. This takes the NanoFire barrel coupler, the rear rail system, and any front end that were developed for the NanoMag and provides a way to use them without adding the magazine system of the NanoMag.

Only the "Basic" front end is provided. More front end STLs are provided via Etsy: https://www.etsy.com/listing/966073544/nanomag-files-digital-stlssteps

Completed Prints of the NanoMini, with more front-end options, are available via Etsy: https://www.etsy.com/listing/965317552/print-to-order-nanomini-for-nerf

Blaster Required:

Nerf NanoFire https://nerf.fandom.com/wiki/NanoFire

-OR-

Nerf Alpha Strike Stinger https://nerf.fandom.com/wiki/Stinger_SD-1

Hardware Required

Didn't you read above? No hardware needed, this is all 3D-printed! Just use wire cutters to cut out the following lengths of 1.75mm filament:(All the part numbers below are prefixed with "a2p" for the filenames, e.g. the coupler has a filename of a2p4.1_....stl)

• 1x 7mm for Flip Up Sight (7.2c)
• 3x 16mm for connecting Coupler (4.1) and Rear Rail (5.1a) to Adapter (1.2)
• 1x 23mm for connecting Front End (7.*) to Adapter (1.2)
• 2x 24mm for connecting Rear Sight (6) to Rear Rail (5.1a)
• 3x 32mm for connecting Coupler (4.1) and Front End (7.*) to Adapter (1.2)
• 1x 56mm for connecting Rear Rail (5.1a) to Rail Clip (5.1b)

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.2mm Layer Height, 0.4mm Nozzle

Infill:

Filament: Hatchbox PLA Orange

Notes:

Category: Sport & Outdoors