1 / 1
Alternative bowden tube clip for " Prusa Core one L " , or other Printer / easy to remove — zdjęcie 1

Alternative bowden tube clip for " Prusa Core one L " , or other Printer / easy to remove

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An alternative bowden-tube-clip, thats easyer to remove than the normal one

Ocena
5 / 5
Polubienia
9
Pobrania
30
Wydruki
1
Wyświetlenia
268
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

Instead of using the standard filament holder on my Prusa Core one L, I use a Filament dryer and feed the filament directly from there into the printer via a Bowdentube.

If the printer runs until the filament spool is empty, I have to detach the Bowdentube from the printer, to remove the remaining filament.

Doing this with the standard Bowden-Clip is quite tedious. Therefore, I designed a new clip in Blender that is much easier for me to remove.

I use PETG for the print. PLA is no good option, because its to hot in the Printer for PLA.

ABS or ASA is just as suitable for printig.

I designed this clip specifically for the location shown in the pictures. For any other locations or othe printer, you must verify that the longer clip does not interfere or cause problems.

It works perfectly on my current version of the " Core One L " for me. 

Try it out to see if its a good solution for you, too.

Important:

After installation, please be sure to check wether it might collide with any moving parts on your printer during printing (especially if you intend to use this part on a different printer model).

I hope you enjoy this upgrade!

If you like it, please leave me a like ;-)

Tagi