P1S Temp Display Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small print to mount a temp display in the opening on the top right of the P1s (and some other BL printers)
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 21
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Small print to mount a temp display onto the P1S. I print in my garage, so I like to know what my enclosure temps hover around during printing as the garage temp changes seasonally.
I placed a small support under the lower insert piece as it is at a bit of an angle. It may print fine without supports, though I didn't try. Recommend a brim inside and outside of the print as the walls are thin. The design is meant to print with the "back" of the housing on the bed.
This uses the upper opening to pass the wire into and hold the housing solid (just friction fits into the hole). The temp probes that I use are at the link below. You need to break the little spring tabs off the side to fit this, they're not really needed.
https://www.amazon.ca/dp/B016HSDWTE?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_3