1 / 6
Interstuhl F160 backrest adjust mechanism repair kit / Rückenlehne Verstellmechanismus Reperaturkit — zdjęcie 1
1 / 6

Interstuhl F160 backrest adjust mechanism repair kit / Rückenlehne Verstellmechanismus Reperaturkit

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a repair kit for the backrest adjust mechanism of the Interstuhl F160 office chair.

Ocena
0 / 5
Polubienia
2
Pobrania
2
Wydruki
0
Wyświetlenia
32
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Public Domain

After years of using the backrest adjustment mechanism of my Interstuhl F160 office chair, i heard a "snap" sound and the lever on the left side of the chair which controls the backrest position wouldn't do anything anymore.

I created this repair-kit to replace the broken metal rod without needing to completely disassemble the entire chair mechanism (which would probably be impossible to but back together because of the giant loaded spring)

Here are step-by-step instructions on how to install the the repair-kit. I numbered every step in the pictures.

  1. Remove the backrest and seat cushion (should be straight forward). Afterwards you should see the raw chair mechanism.

  2. You should notice this broken metal rod. This connects normally to a screw which can be moved up and down to control the position of the backrest. Remove the screw (preferably with a magnetic screwdriver) and get the other half of the broken rod out of the way as good as possible (it will still be attached to some other point, but i didn't managed to remove it completely since you cannot remove the black metal cover without completely disassembling the whole chair mechanism).

  3. Now we need to remove this silver metal bracket.

  4. Remove the lever controlling the reclining function of the back rest. First remove the screw on the other side, then try pulling the lever out with some decent force. The plastic piece where the broken metal rod is connected to will come lose. You can throw that away.

  5. Put together the repair-kit like in the picture. Make sure that the part that gets slided onto the lever is in the right orientation. There are some nubs on one side which keep it in place. Also make sure that the wider side of the printed bolt points outwards so it cannot fall out. (You can of course use a metal bolt for better reliability. I would also advice greasing the bolt a little bit)

  6. Now slide the assembled part into the chair mechanism like in the picture. You may need to bend the plastic rail a little bit for that to work.

  7. Use the screw we previously removed to secure the rail. Don't tighten it completely. It needs a little bit of wiggle room to still work.

  8. Slide the lever to control the reclining back into the mechanism like in the picture and put the screw back in. If done correctly it should be pretty secure. (Now if you put some of your body weight onto the part where the backrest is normally attached, you should be able to control the reclining with the lever just as before). After you validated that everything works, put the silver metal bracket back into place from step 3.

At last, you can put back together the seat cushion and backrest. You may notice that you now need to turn the lever way less to adjust the backrest than before. I also don't have any idea how well this will hold up, so i would advice to not crank the lever too hard when adjusting the backrest. I used it like this for over a month now without any problems. Of course this will also depend on the type of filament you are using.

Tagi