Closing lid for Wordclock
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
AWSW's WordClock (see https://www.printables.com/model/1125181-wordclock-16x16-2025) is a great gadget for your home. I really appreciate it.
But it is - as usually - the small things that make things better: In this case, the power USB cable goes into a hole on the backside. It is possible that by pulling it it may lose contact to the internal USB socket.
Therefore I quickly made a TPU knob to fit into the hole to tightly hold the USB cable. Since it is made of TPU rubber, it can be easily pressed into the hole and closes it (see title picture). It has a prepared slit which should be carefully opened with a sharp knife to insert the cable.
STLs are provided for 3, 4, 5, 6mm USB cable diameters, but if you have a different one, I provided the simple OpenSCAD model to allow adjusting the knob for different cable diameters.
To mention again: use TPU, not PLA for printing. Other than that, no special restrictions such as infill or supports apply - use the default for the material.