Ender 3 Bed Mount for Silicon Brush and SexBolt Z Endstop
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Drill-in rear Ender 3 bed mount for a SexBolt Z Endstop and a silicon nozzle brush
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 161
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- GNU General Public License v3.0
Drill-in Ender 3 bed mount. Fits to hartk's SexBolt Z endstop and a custom silicon brush holder included here.
The mount is sized to my Ender 3, which uses silicon spaces instead of bed springs, so it may not work on unmodified Ender 3s.
The design also requires enough Y travel to allow the nozzle to reach behind the bed. I had just enough clearance after replacing my y axis rollers with linear rails. The stock wheels may not give enough clearance. In this case you can move the y axis forward one set of screws.
Hardware
3x M3 Screws to secure the mount to the bed
4x M3 nuts, 2 each for the endstop and brush holder.
2x 20mm M3 screws, for the brush holder
2x 25mm M3 screws to mount the endstop
1 Bambu labs A1 silicon nozzle brush, 8 mm by 37mm (https://www.amazon.com/Heatbed-Replacement-Accessories-Cleaning-Compatible/dp/B0F8MFM7H6)
Assembly
I used the printed part as a guide, requires 3 M3 screws and I used 3 M3 locking nuts, but regular nuts are probably fine. The endstop and brush holder both require 2 M3 screws and 2 m3 nuts. You should be able to roll the nuts in from the sides of the bed mount. I used a Bambu labs A1 nozzle brush for the brush, and stuck it on with the provided adhesive.