1 / 8
Starlink Mini Pole Mount — RRS / Arca Plate Adapter (flush angled top) — zdjęcie 1
1 / 8

Starlink Mini Pole Mount — RRS / Arca Plate Adapter (flush angled top)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of the 2nd-gen pole mount with a wedge cap so a Really Right Stuff / Arca plate sits flush on the angled mount.

Ocena
0 / 5
Polubienia
1
Pobrania
11
Wydruki
0
Wyświetlenia
138
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

What this is: a remix of ActualPepperoni's Starlink Mini 2nd-gen pole mount adapter, modified so a Really Right Stuff (Arca-Swiss) quick-release plate mounts flush. Full credit to the original — this only changes the top/insert side.

The problem it solves: on the original, the insert sits recessed below the mount's angled rim, so a longer Arca plate can't reach it. This version caps the recess with a wedge that matches the rim's ~8.8° slope and re-angles the insert bore to match, so the plate sits flat and the screw runs in true.

Hardware: same 1/4-20 brass heat-set inserts as the original. Amazon link from original post.

Print settings I used (ASA):

  • Material: ASA (printed in Prusament Orange)

  • Walls/top/bottom: 8 perimeters, 8 top & bottom layers

  • Infill: 70% gyroid (overkill for the load, but it's a small part and I wanted margin)

  • Layer height: [fill in what you ran]

  • Brim, plus Magigoo on the plate; enclosed chamber ~50 °C with filtration

Orientation: place the sloped insert face flat on the bed, socket opening facing up. Insert hole prints vertical (clean heat-set, good pull-out) and no supports needed for the cavity.

Insert install: heat-set iron ~270–285 °C, press the insert in square from the angled face until flush; the relief above the seat gives the melt somewhere to go.

Files: STL for slicing yourself, plus the 3MF with my exact ASA settings if you want to print it the way I did.

Tagi