1 / 4
Scrubi Golf Club Cleaner Mount for Caddytek Golf CaddyLite 11.5 V3 — zdjęcie 1
1 / 4

Scrubi Golf Club Cleaner Mount for Caddytek Golf CaddyLite 11.5 V3

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This two-piece bracket adapts it to the CaddyTek CaddyLite 11.5 V3. Print both pieces in PETG, dry-fit them on your cart

Ocena
0 / 5
Polubienia
4
Pobrania
12
Wydruki
0
Wyświetlenia
180
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Scrubi makes a great golf club cleaner designed for push carts, but their stock mount only works with clip-gear style frames. This two-piece bracket adapts the Scrubi cleaner to standard tube-frame push carts -- in my case a CaddyLite 7.1.5, though it should work on any cart with a similar round/oval frame tube.

Design

The bracket prints in two pieces by design. The lower half clamps around your cart's frame tube; the upper half holds the Scrubi cleaner at an angle. Printing them separately lets you dry-fit, set your preferred angle, and then glue once you're happy with the position. No hardware required -- just CA glue at the joint and a friction fit on the cleaner itself.

Material

Print in PETG. This thing lives outdoors, gets wet every round, and sits in a hot car trunk all summer -- PLA will not hold up. I've run this bracket through two full seasons without any warping, cracking, or joint failure.

Print Settings

  • Material: PETG (strongly recommended)

  • Supports: May be needed depending on orientation

  • Infill: 30%+ recommended for the clamp piece

  • Layer height: 0.2mm works fine

Assembly

  1. Test fit both pieces on your cart frame and dial in the angle

  2. Apply CA glue at the joint between the two pieces

  3. Hold until set, then drop the Scrubi cleaner in

Compatibility

Designed around the CaddyTek CaddyLite 11.5 V3 frame tube. If your cart has a different tube diameter you may need to scale the clamp piece or remix the fit. The Scrubi cleaner pocket should work with the standard Scrubi push cart cleaner.