1 / 8
Wall mounted Organic Toilet brush holder - two parted for cleaning - Wand Toilettenbürsten Halter — zdjęcie 1
1 / 8

Wall mounted Organic Toilet brush holder - two parted for cleaning - Wand Toilettenbürsten Halter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Organic Wall mounted toilet brush holder mounted with 3M double sided tape, with two parts for easy cleaning.

Ocena
0 / 5
Polubienia
4
Pobrania
19
Wydruki
0
Wyświetlenia
103
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Bathroom
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

My personal design of an organic, wall mounted toilett brush holder.

Considerations for the design:

I don't like standig Toilett brush holders, as they're always in the way for cleaning.

Second priority I didn't wand to drill in the wall slab, so I designed it "large" enough that it can be mounted with double sided vhb tape. There are some from Tesa with special glue, but they're all of glas, my kid destroyed two of those . . . 

Third priority was to make it out of two parts in order to be able to clean the "internal" part can be taken out for cleaning.

Finally I wanted a round, organic design.

Printing instructions:

Settings:
  • Printed with 0,2mm layer hight, with 20% infill.

  • The logo T@K should be placed on the printbed.

  • Enable support from buildplate (you can use tree support).

Bonus:
  • On the top part, you can add a print modifier on the most top 10mm to reduce the layer height to 0,1 mm for a finer finish.

Material:
  • PLA is fine, if you want to clean the top part with hot water, you might want to use PETG or ABS.

  • Mine is printed in extrudr greentec pro carbon - the carbon gives a great finish with night reflections (use hardend nozzle :)

Tolerances and Postprocessing instructions READ!:

The tolerances are pretty tight, in order to avoid the top part to be pulled out by taking out the brush.

Printed with Prusa Core L the tolerances work, not sure with other less precise printers. If you hace issues, slightly scaling the top part a bit down (0,1-0,5%) might help.

The bottom part inside has a slight chamfer for some friction. Before mounting insert the pieced slowly into each other and turn them a couple of minutes to create some clearance. Don't push fully together to early, it might geht hard to get the pieces apart. Work your way with some patience. You'll feel once it's fine.

See my pictures and you see the "scratched" sides. With some patience you get the PERFECT FIT!

Wall Mounting:

As mentioned in the introduction, my goal was to avoid drilling into wall slabs. 3M VHB tape gives a secure hold (an earlier prototype held years on the wall).

To wall mount, stick 3M VHB tape ONLY to the bottom part and stick it to the wall.

Bonus - it's removable:

Using 3M VHB tape, you can also remove it from the wall again if necessary. On slabs, its destructionless. Of course it takes some fidelling/force but it works.

Tagi