Long Handle Coffee Measure with easily removed supports
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an improved design of my Long Handle Coffee Measure, redesigned so the supports are much easier to remove.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 32
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
This coffee measure is great for using with coffee bags too small to get your hand into. This part is an improved version of my earlier design. The bottom of the handle is parallel to the build plate and has two thin rails that need support, making support removal much easier than my first design.
I have included details of support settings for the Prusa slicer. I avoided using "Snug" supports which in this case make supports harder to remove. The settings I chose have the top interface layer with 1 mm wide spacing which is perpendicular to the thin part walls it supports. I set the overhang angle for supports to 30 degrees so no unnecessary supports were generated. These settings minimize contact between the supports and the part. I used PETG and the supports easily broke off in one piece leaving a smooth surface on most of the handle. The part could also be printed in PLA, ASA, ABS etc,
I printed with a Prusa MK4S and the following settings:
Layer height 0.20 mm or smaller
8 top and 8 bottom layers
4 perimeters
20% rectangular infill
overhang threshold = 30 degrees to avoid unneeded supports
top support interface layers = 1 (light) with 1 mm spacing
I also added a hole for hanging the scoop and reduced the walls to 1.5 mm.