1 / 10
Fire Horse Sculpture & Bookend (AMS Ready / No-AMS / Split Parts) — zdjęcie 1
1 / 10

Fire Horse Sculpture & Bookend (AMS Ready / No-AMS / Split Parts)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Stylized Fire Horse bookend and shelf sculpt. Optimized for razor-sharp AMS or easy hand-painting!

Ocena
0 / 5
Polubienia
11
Pobrania
40
Wydruki
0
Wyświetlenia
150
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Sculptures
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I designed this stylized Fire Horse head to work either as a functional bookend or as a standalone shelf display.

I spent a lot of time manually cutting and rebuilding the mesh boundaries for the mane and the eyes. If you are printing this with an AMS, MMU, or dual-extruder setup, the color transitions are razor-sharp. You won't get any of those jagged, bleeding edges that happen when people just use the slicer paint bucket on blocky geometry.

Two ways to display it:

  • As a Bookend: Print it with the included L-bracket base.

  • As a Shelf Sculpt: The horse has a perfectly flat back and bottom, so you can skip the bracket entirely and just push it flush against the wall on a shelf.

No AMS? All good. The file is set up with the horse and the bracket as separate bodies. You can print them completely separately. This makes it incredibly easy to print the horse in a light primer color, hand-paint the flowing mane, and then glue it into the dark bracket later.

Print Settings & Profile Recommendations

  • Layer Height: I highly recommend 0.08mm or 0.12mm. The mane has a lot of smooth, organic sweeps, and a lower layer height really makes it look like a molded sculpture rather than a 3D print.

  • Nozzle: Standard 0.4mm works great, but if you have a 0.25mm or 0.2mm nozzle, the details and sharp color boundaries look absolutely incredible.

  • Infill: 10% to 15% Gyroid is plenty. Note: If you are actually using this to hold up heavy books, I recommend bumping up the wall loops to 4 or 5 and increasing the infill on the bracket base to give it some physical weight.

  • AMS Flushing Volumes: If you are doing a multicolor print with a dark body/bracket and a bright orange mane, make sure to manually bump up your flushing volume multiplier. You want to make sure all the dark plastic is purged so the orange stays vibrant and doesn't get muddy.

  • Supports: Minimal supports needed depending on your orientation, but standard snug supports under the chin and the lowest tips of the mane work perfectly.

Tagi