Shoe Insole Drying Holder for Clothes Drying Rack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small holder for drying shoe insoles on a clothes rack. Keeps wet insoles off the heater and floor.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 69
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
Wet shoe insoles? Yeah, they always end up somewhere annoying.
I made this small holder so two insoles can dry properly on a clothes drying rack instead of lying on the heater, the floor, the windowsill or wherever they usually stay “just for a moment”.
The insoles are pushed in from below and held by the wavy clamp arms. The hook is made for typical drying rack rods around 8 mm.
The model prints flat and does not need supports.
I included README files in English and German.
The OpenSCAD file is also included, so you can adjust the holder if needed.
Depending on how thick your insoles are, you can either scale the model slightly in your slicer or adjust the OpenSCAD values directly. For the clamp width, change grip_gap. For the drying rack rod, adjust rod_diameter or rod_clearance.
Recommended print settings:
- Material: PLA / PLA+
- Layer Height: 0.20 mm
- Wall Line Count: 4
- Infill: 30-40 %
- Supports: No
- Build Plate Adhesion: Skirt