Left Handed Whammy Bar Mod for CRKD Guitars
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Swap the whammy bar from the right to the left
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 154
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution
I tried to design this mod to be as simple and sturdy as possible. installation is pretty straightforward, and you should be able to figure out the assembly just by looking at the photos.
Of course, if you run into any issues, feel free to send me a message.
Unfortunately i won't have a solution ready for relocating the CTRL button into the original whammy housing so you will need to use my star power mod or come up with your own workaround.
You will need to sand off about half a millimeter from the headless screws. You can try using 5 mm ones but they barely fit. You could also use 6 mm ones without sanding but the tip of the screw will dig into the rubber section of the whammy bar. Unfortunately there isn't much room to work with here.


Insert the mini ball bearings into the holes. then use two 20 mm screws here to assemble the main structure.


Now you can screw the whammy base onto the main structure.


Remove the battery. Now you can remove the star power board and the battery pogo pin connector.
Place the main structure in the same position as the original star power board and secure it with the original screws.


Then you can reassemble the battery pogo pin connector on top of the main structure and add the support brackets.


The top piece uses a 5 mm screw to secure the spring and three 10 mm screws that need to be screwed into the top of the main structure. Basically the spring gets compressed as you screw the top piece into place.



These are the measurements you need to cut the zip ties.


As you can see below, these are the parts of the sensor housing. For the cylindrical part, first insert the long zip tie (red) then the short zip tie (yellow). Use two 20 mm screws here.




Now you can insert the sensor inside the housing and close it.


Place the sensor housing under the support bracket and screw it into place. Use 5 mm screws here


Insert the zip tie into the whammy base hole. And that's it!
You will need to recalibrate your guitar after this.

Requirements
4x M3 20mm screws
3x M3 10mm screws
3x M3 5mm screws
2x M3 6mm screw WITHOUT HEAD
2x mini ball bearings 3x6x2.5mm
20cm male to female JST PH cable
zip ties 2.5mm width
Disclaimer
Warranty: Opening your guitar will probably void your warranty.
Liability: Proceed at your own risk. I'm not responsible for any damage to your hardware